OBD2 USB Car Diagnostic Cable

- This cable works on all VW, Audi, Seat and Skoda vehicles with a 16 Pin Diagnostic Connector.
- Can not work if your car uses a protocol/bussystem like VPW, PWM or CAN-bus.
- Terminal K = bus of communication
- Terminal L = ignition for waking up car computing system (ECU: Engine Control Unit)
- This K/L diagnostic interface & cables work on ISO/KWP (Key Word Protocol) launched after 1996 only
-Supported also ISO9141 protocol; supports VAG-COM version 409.1 or older
- The Cables may work with some versions of the Carsoft, but carsoft used a lot of different interfaces during the different versions and also had some custom interfaces.
- Capability includes: encoding drivers, encoding key with immobiliser,service review set, drivers comparison, regulation of turn of waste run, diagnostics of executive elements and many others capabilities